Scantech Vega V-1010 Manual de usuario descargar pdf (Pagina 21)

Scantech-ID VEGA Linear Imager 17

4.3 V-1010BT SET UP BLUETOOTH COMMUNICATION

Before the VEGA scanner can be used for normal operation, Bluetooth

communication must be set up between the VEGA scanner and cradle,

Scanner client mode or to a Bluetooth application device, Scanner Server

mode.

4.3.1 Pairing

Pairing refers to when a VEGA scanner has been linked or paired to a

specific cradle by scanning that cradle’s Bluetooth MAC address code, this

Bluetooth MAC address code is unique for each cradle. This address code is

located on the bottom side of the cradle. The pairing of a VEGA scanner to a

cradle is one to one. Only one VEGA scanner can be paired to a cradle at

any point in time.

4.3.2 Set up Client Mode Communication

To set-up the communication between the VEGA scanner and the cradle

follow the next steps:

1. The VEGA scanner must scan “Scanner Client Mode ON/Scanner

Server Mode Off” barcode, to set the VEGA scanner in client mode.

2. Scan the Bluetooth MAC address code located on the bottom of the

cradle.

3. When the Bluetooth MAC was successfully scanned, scanner will

initiate with short beep sounds. Blue and red led will also blink

followed by a long beep sound.

4. Wait approximately five seconds, for completing the connection

process. Blue led will slow flash on scanner for connected the

cradle.

5. If successful, the blue led on the cradle will be on.

6. If the connections failed the scanner indicates with shot beep sounds

and the cradle with blinking blue led.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 120 121

Sin comentarios

Scantech Vega V-1010 Manual de usuario Pagina 21