Scantech V-1020 Manual de usuario descargar pdf (Pagina 19)

Pulse

A reading session begins when beam is activated and stays

on until a period of inactivity lasting the time

specified by the timeout.

After the timeout, the scan engine turns off.

Flashing

Flashing mode allows power up the lighting and decoding

are on (no need to activate the trigger line) and after a

period of inactivity lasting the time specified by the

trigger timeout, the scanner starts flashing, checking

for a bar code to be read.

When a bar code is detected, the lighting and decoding

automatically turn on and stay on until another period of

inactivity (timeout), after the timeout the scanner

starts flashing again.

Autostand

This mode allows you to switch from Flashing trigger mode

to Level trigger mode.

Autostand begins in flashing mode: At power up the

lighting and decoding are on (no need to activate the

trigger line) and after a period of inactivity lasting

the time specified by the trigger timeout, the scanner

starts flashing.

To switch to Level trigger mode activate the trigger line

(press the trigger).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 50 51

Sin comentarios

Scantech V-1020 Manual de usuario Pagina 19